How do I fix the fold knob on my Wolf loom?

On older Wolf looms, if you completely unscrew the fold knob, the metal T-nut that the knob screws into can slip down inside the castle far enough that you cannot put in the fold knob. The pictures here show a newer loom. With the fold knob removed, you can see that the hole in the metal T-nut is still accessible.

 metal T-nut in Wolf castle side

Metal T-nut in castle side

 

plastic T-nut slide in metal T-nut

Plastic T-nut slide in metal T-nut—T-nut slides are now black.

 

Installing fold knob

Installing fold knob

 

Part of the hole in the metal T-nut should be visible. You can insert the tip of a straightened paper clip in the hole, then pull the T-nut up to expose the hole. You can put something like a screwdriver under the T-nut to hold it up while you reattach the plastic T-nut slide, fold up supports, and fold knob.

Be sure to put the front fold up support next to the plastic T-nut slide, then the rear fold up support on top of the front fold up support. 

If your loom is unfolded, you might need to pull on the fold support bars to get the holes to line up for the knob.

Note: Loosening both knobs all the way or removing them can cause the loom to collapse which could result in injury.

Replacing the Metal T-Nut

If you are unable to get the fold knob screwed into the metal T-nut, it's possible that the threads in the screw hole are stripped. You can order a replacement T-nut here.

To install a new T-nut, you will need to do the following:

  1. Remove the shafts—all four on a 4-shaft loom or the four at the front on an 8-shaft loom.
  2. Remove the metal channel on the inside of the castle.
  3. Take out the metal T-nut and replace it with a new T-nut.
  4. Replace the metal channel.
  5. Replace the shafts.

← Older Post Newer Post →

© Schacht Spindle Company