Beater Pin Kit for Wolf/Standard Floor Looms

$10.00 You Save

SKUR-16-980349

Includes one beater pin and chain, one beater pin holder, and one screw for the holder.

Fits all Wolf looms and Standard Floor Looms.

Read Before Ordering
How to Install
Read Before Ordering

If your loom does not have a hole for the beater pin, it's easy to drill one. The location doesn't have to be exact—it just has to be close enough for the chain to reach from the holder to the large hole for the pin.

Mark a location for the holder's screw:

  • for a Standard Floor Loom, on the right upper side support about 1" in front of the castle
  • for a Wolf loom, on the right outside leg about 2" down from the large hole for the pin.

Drill a small pilot hole with a 13/64" bit for the #6 x 5/8" sheet metal screw. Follow the instructions below.

How to Install

You will need a #2 Phillips screwdriver.

  1. If necessary, use the screwdriver to remove the old beater pin and holder.
  2. Insert the screw through the hole in the end of the beater pin chain and through the hole in the beater pin holder. From the outer side of the loom, fasten the screw into the small pilot hole in the outside right leg (for Wolf looms) or the right upper side support, between the right castle side and the ratchet dog (for Standard Floor looms).