Wolf looms

Schacht refers to loom accessories by the loom's weaving width. See the diagram for measurements of Wolf loom heddle bars.
Standard Floor Looms

See the diagram for measurements of 36" and 45" heddle bars.
NOTE: If you have a 42" loom, you will need custom heddle bars. Please contact us for further assistance.
Measure a heddle bar you have

If you need a custom size, see "How to install" below—remove a heddle bar from a shaft and measure its length. Contact Customer Service to order.

1 4

Schacht Spindle Company

Heddle Bars for Wolf and Standard Floor Looms

Schacht Spindle Company | SKU: R-12-9210036

$9.25

Weaving width

Find a Dealer Near You

Lead Time

Most orders will ship within 2 weeks. Orders for floor looms and spinning wheels will ship within 9 weeks.

Read before ordering

Includes one heddle bar—each shaft of the loom requires two heddle bars.

Fits all Wolf looms and all Standard Floor Looms except the original 42" weaving width.

If you need a heddle bar in a custom length, contact Customer Service. There is a cut fee for custom sizes.

How to install

Remove the shaft from the loom: disconnect the hex nut holding the shaft to the jack, then lift the shaft out of the castle.
Lay the shaft flat on a working surface. Tie together any heddles on the shaft: run one long string through the tops of the heddles, then around to the bottoms of the heddles. Knot the string securely.
If the shaft has heddle bar hooks, release the heddle bar from its hook: Push up on the slide lock on the heddle bar hook and pull the heddle bar out of the hook. Release the slide lock.
Flex the heddle bar(s) enough to remove one end from the slot in the side of the frame. Remove the other end from its slot in the frame.
If you're replacing both heddle bars in the shaft, repeat Steps 3 and 4 for the remaining heddle bar.
You can now replace one or both heddle bars in the shaft. Slide a new heddle bar through the tops of the heddles. Slide another heddle bar through the bottoms.
Replace the heddle bars in the shaft frame. Insert one end of each heddle bar in the slot in the frame. Flex the heddle bar and insert the other end into its slot. Divide the heddles approximately in half and push them to either end of the heddle bar. Push up on the slide lock and place the heddle bar back on the hooks.
Reinstall the shaft in the castle. Reattach the hex nut to the jack.

Explore