See the assembly manual for your loom, found on this website. Assembly manuals for flat-packed (international) looms explain how to install an assembled beater—follow these steps in reverse to remove the beater.
To replace the beater support:
- Remove the hardware attaching the support to the inner face of the beater side. Remove the old beater support.
- Set the new beater support in position on the inner face of the beater side, aligning all holes. From the outer face of the beater side, insert a carriage bolt through each hole. From the inner side, add a washer to the bolt shaft, then add a hex nut. Tighten the hex nuts as much as possible.
Replace the assembled beater on the loom, following instructions in the assembly manual for flat-packed looms.
